Step 1: Main Unit Installation
Complete the TT6000 installation as per the TT6000 Quick Install Guide.
When selecting a mounting location for the TT6000 ensure there is sufficient room for any of the additional parts required for this and other accessories.
Step 2: WBD Installation
Connect the WBD to the TT6000.
Plug the 6-pin MOLEX connector of the WBD/TT6000 harness (with 4 wires) into the WBD as shown in the diagram (see below).
Plug the other 6-pin and 8-pin MOLEX connectors with 2 wires each) into the CBL-0040 6-pin and 8-pin MOLEX receptacles, respectively.
Step 3: Bluetooth Beacons
Serial Number: MAC 00:11:22:33:FF:EE
Please ensure the beacon is securely mounted to equipment/asset to prevent loss or damage.
IMPORTANT! Must be Tested
Call to test the GPS tracking device before closing up the dash. Failure to follow these instructions will damage the equipment and void its' warranty.
1-780-391-3800 Toll-Free 1-855-287-4477