Skip to main content

TT6000/WBD Gateway - Titan Beacon Quick Install Guide

This article contains a quick installation guide for the TT6000/WBD Gateway device with Titan Beacon accessory.

Step 1: Main Unit Installation

Complete the TT6000 installation as per the TT6000 Quick Install Guide.

  1. When selecting a mounting location for the TT6000, ensure there is sufficient room for any of the additional parts required for this and other accessories.

Step 2: WBD Installation

Connect the WBD to the TT6000.

  1. Plug the 6-pin MOLEX connector of the WBD/TT6000 harness (with 4 wires) into the WBD as shown in the diagram (see below).

  2. Plug the other 6-pin and 8-pin MOLEX connectors with 2 wires each) into the CBL-0040 6-pin and 8-pin MOLEX receptacles, respectively.

Step 3: Bluetooth Beacons

Serial Number: MAC 00:11:22:33:FF:EE

  1. Please ensure the beacon is securely mounted to equipment/asset to prevent loss or damage.

❗ IMPORTANT! Must be tested.

Call to test the GPS tracking device before closing up the dash. Failure to follow these instructions will damage the equipment and void its warranty.


1-780-391-3800

Toll-Free 1-855-287-4477

Did this answer your question?